Atlas Copco MT Focus 6000 Configuration Manual

MT Focus 6000 EN Liability
© Atlas Copco Industrial Technique AB - 9839 0527 01
3
Liability
Many events in the operating environment may affect the tightening process and shall require a validation
of results. In compliance with applicable standards and/or regulations, we hereby require you to check the
installed torque and rotational direction after any event that can influence the tightening result. Examples
of such events include but are not limited to:
■
initial installation of the tooling system
■
change of part batch, bolt, screw batch, tool, software, configuration or environment
■
change of air- or electrical connections
■
change in line ergonomics, process, quality procedures or practices
■
changing of operator
■
any other change that influences the result of the tightening process
The check should:
■
Ensure that the joint conditions have not changed due to events of influence.
■
Be done after initial installation, maintenance or repair of the equipment.
■
Occur at least once per shift or at another suitable frequency.

Atlas Copco MT Focus 6000 Specifications

General

Brand	Atlas Copco
Model	MT Focus 6000
Category	Controller
Language	English