OPERATOR’S AND SAFETY MANUAL
1NO0039UK-00
Zebra 12
IF THIS LIGHT COMES ON AND AN ALARM SOUNDS WHEN THE WORK PLATFORM
IS RAISED, LOWER THE PLATFORM IMMEDIATELY, STARTING BY BRINGING THE
TELESCOPE BACK IN.
15- Overload indicator light:
This light flashes when the working platform's load capacity is exceeded.
Refer to Section 5.2 –Load control.
15- Engine fault indicator light:
This light comes on during start up and must go out after the engine has
started.
When the engine is running, this light flashes if there is an alternator fault
(the alternator is no longer correctly recharging the battery).
When the engine is running, this light comes on steady when the diesel
engine oil pressure is abnormally low or when the cooling fluid
temperature is abnormally high: CUT the diesel engine as quickly as
possible.
Refer to 4.2.3 – Diesel engine safeties.
15- Validation indicator light:
This light is on when the enable pedal is activated and a movement can be
controlled.
15- Maintenance / System fault indicator light:
This light flashes slowly when a maintenance / pre-scheduled
maintenance operation is required.
The light is on steady if there is a fault in the control system.
Refer to 5.2.3 – System fault.
15- Fuel level indicator light:
This light comes on when the fuel level in the tank is low: add fuel in the
tank.
Refer to 7.1.2 – Fuel.
15- Preheating indicator light:
This light comes on when the engine is warming up and goes off once the
engine is started.
Refer to Section 4.2 – Diesel engine operation.
To Next Page
Loading...
Need help?
General
