Atronic Harmony - PAYTABLE CONVERSION; Paytable Software; Button Panel; Legend Foils

45
February 2006
Harmony™ Operating Manual
PAYTABLE CONVERSION
In order to change the number of lines or the bet per
line settings or the payout percentage, it is necessary
to re-configure the paytable settings or to change
the paytable EPROM. Following areas of the machine
are involved in a paytable conversion.
Paytable Software
Button Panel / Legend Foils
Paytable Software
Configurable paytable software allows to change
paytable settings by means of a Clear Memory
Procedure. Change of EPROM is not necessary. After
a RAM Reset the Initial Setup starts automatically,
allowing to re-configure paytable settings.
-> See manual " Software / Basic Setup" chapter Initial
Setup for details.
Paytable EPROMs are available as fully or partly
configurable versions. If the desired settings are not
included within the installed paytable EPROM, a
EPROM change is necessary. Change of paytable
EPROM requires a Clear Memory Procedure.
Button Panel / Legend Foils
A button panel conversion is necessary, if a new
paytable setting with different LINES and BET PER
LINES steps is used. In most cases a button panel
conversion can be done by changing the legend foil
button inserts. A legend foil kit consists of a group
of button inserts.
Use a gaspipe pliers with soft clamping to carefully
remove the button lens caps.
MACHINE CONVERSION
Note:
Use only paytable EPROMs
that expressly match to a
particular software set
Note:
The Clear Memory Procedure
(RAM Reset) clears all soft
meters and game settings!