Audient iD48 - Page 41

41
DAW ADAT
When set to DAW ADAT, Line Outputs 1-8 are fed from output channels 9-16
respectively.
Please note that it’s possible to assign each Line Output channel dierently. For example, you
could have Line Outputs 1+2 set to DAW Analogue and being fed from output channels 1+2,
and at the same time, Line Outputs 3+4 are set to DAW Digital and are being fed from output
channels 11+12.
Along with each input channel also having an independent Mic Mode setting, this provides a
huge amount of routing flexibility when incorporating external hardware equipment into your
setup.
For example, the flexible routing makes the iD48’s Line Outputs perfect for adding hardware
eects, such as compressors, or reverbs as inserts in your DAW. The process of setting up
hardware inserts will dier between DAWs and therefore, it is outside of the scope of this
manual to explain this process. We’d recommend consulting the documentation for your DAW
to find further information.