Copyright © 2006-2009 AudioNote Kits
www.AudioNoteKits.com
audionotekits@rogers.com
Page 49
Section 15: Powering On and Testing
Installing the FUSE – Pull out the fuse drawer and flip it over – then push in the fuse into position and insert back in the
IEC receptacle.
The switch position above shows the unit OFF – when the 1 is pressed flush with the chassis the unit will turn ON.
Power On Procedure
If you have a Variac we will take advantage of it – it is a
very useful device for slowly turning on the power to your
amplifier.
If you do not have a Variac then you will have to be a little
more cautious and be in a position where you can switch off
at the slightest hint of anything not seeming correct.
To Next Page
Loading...
