MediaPack SIP User’s Manual 5. Configuring the MediaPack
Version 4.6 105 June 2005
5. To save the changes so they are available after a power fail, refer to Section 5.9 on page
161.
Table
5-23: Authentication ini File Parameter
Parameter Name in ini File Parameter Format
EnableCallerID_X
EnableCallerID_<Port> = <Caller ID>
Caller ID:
0 = Disabled (default).
1 = Enabled.
If not configured, use the global parameter ‘EnableCallerID’.
Note 1: The numbering of ports starts with 0.
Note 2: This parameter can appear up to eight times for 8-port gateways,
and up to 24 times for MP-124.
5.5.8.5 Call Forward
The VoIP gateway allows you to forward incoming IPÆTel calls (using 302 response) based on
the VoIP gateway port to which the call is routed (applicable only to FXS gateways).
The Call Forwarding Table is applicable only if the Call Forward feature is enabled. To enable
Call Forward set ‘Enable Call Forward’ to ‘Enable’ in the ‘Supplementary Services’ screen, or
‘EnableForward=1’ in the ini file (refer to Table
5-6).
¾ To configure the Call Forward table, take these 4 steps:
1. Open the ‘Call Forward Table’ screen (Protocol Management menu > Endpoint Settings
submenu > Call Forward option); the ‘Call Forward Table’ screen is displayed.
Figure
5-25: Call Forwarding Table Screen
2. Configure the Call Forward parameters for each port according to the table below.
3. Click the Submit button to save your changes.
4. To save the changes so they are available after a power fail, refer to Section
5.9 on page
161.
To Next Page
Loading...
