MediaPack SIP
MediaPack SIP User’s Manual 38 Document #: LTRT-65405
3.2 Installing the MP-11x
¾ To install the MP-11x, take these 3 steps:
1. Unpack the MP-11x (refer to Section 3.2.1 below).
2. Check the package contents (refer to Section
3.2.2 below).
3. Mount the MP-11x (refer to Section
3.2.4 on page 39).
4. Cable the MP-11x (refer to Section
3.2.5 on page 33).
After connecting the MP-11x to the power source, the Ready and Power LEDs on the front panel
turn to green (after a self-testing period of about 2 minutes). Any malfunction in the startup
procedure changes the Fail LED to red and the Ready LED is turned off (refer to Table
2-7 on
page 27 for details on the MP-11x LEDs).
You’re now ready to start configuring the gateway (Section
5 on page 47).
3.2.1 Unpacking
¾ To unpack the MP-11x, take these 6 steps:
1. Open the carton and remove the packing materials.
2. Remove the MP-11x gateway from the carton.
3. Check that there is no equipment damage.
4. Check, retain and process any documents.
5. Notify AudioCodes or your local supplier of any damage or discrepancies.
6. Retain any diskettes or CDs.
3.2.2 Package Contents
Ensure that in addition to the MP-11x, the package contains:
• AC power cable.
• Small plastic bag containing four anti-slide bumpers for desktop installation.
• A CD with software and documentation may be included.
• The MP-11x Fast Track Installation Guide.
To Next Page
Loading...
Need help?
General
