MediaPack SIP
MediaPack SIP User’s Manual 120 Document #: LTRT-65405
5.6.1.4 Configuring the Web and Telnet Access List
Use this screen to define up to ten IP addresses that are permitted to access the gateway’s Web
and Telnet interfaces. Access from an undefined IP address is denied. This security feature is
inactive (the gateway can be accessed from any IP address) when the table is empty.
¾ To manage the Web & Telnet access list, take these 4 steps:
1. Open the ‘Web & Telnet Access List’ screen (Advanced Configuration menu > Network
Settings > Web & Telnet Access List option); the ‘Web & Telnet Access List’ screen is
displayed.
Figure
5-31: Web & Telnet Access List Screen
2. To add a new authorized IP address, in the ‘New Authorized IP Address’ field, enter the
required IP address (refer to Note 1 below) and click the button Add New Address; the IP
address you entered is added as a new entry to the Web & Telnet Access List table.
3. To delete authorized IP addresses, check the Delete Row checkbox in the rows of the IP
addresses you want to delete (refer to Note 2 below) and click the button Delete Selected
Addresses; the IP addresses are removed from the table and can no longer access the
Web & Telnet interfaces.
4. To save the changes so they are available after a power fail, refer to Section
5.9 on page
161.
Note 1: The first authorized IP address you add must be your own terminal's IP
address. If it isn’t, further access from your terminal is denied.
Note 2: Delete your terminal's IP address from the Web & Telnet Access List last. If it is
deleted before the last, access from your terminal is denied from the point of its
deletion on.
Table 5-31: Web & Telnet Access List ini File Parameter
Parameter Name in ini File Parameter Format
WebAccessList_x
WebAccessList_0 = 10.13.2.66
WebAccessList_1 = 10.13.77.7
The default value is 0.0.0.0 (the gateway can be accessed from any IP
address).
Note: This parameter can appear up to ten times.
To Previous Page
Loading...
Need help?
General
