Audison bit One HD User Manual

24
USER'S MANUAL
bit One HD /
5. De-equalization procedure
To perform this procedure, follow the instructions listed below:
- insert the “Setup CD” if the head unit in use is an AUDIO CD Player;
- play track 2 (press Play);
- set all tone controls to zero (0);
- set balance and fader to center (0);
- do not change the volume level previously set through the
inputs level automatic calibration;
Press BACK to go back to the previous step.
Press NEXT to go ahead with the setup procedure.
Press CANCEL to exit the program.
6. De-equalization
A progress bar and specic messages show the
procedure’s implementation.
Once the procedure is completed, the window will show
the message “Press Next to Continue”.
Press BACK to go back to the previous step.
Press NEXT to go ahead with the setup procedure.
Press CANCEL to exit the program.
Once the procedure is completed the window will show
the source equalization curves.
When activated, “De –Eq on/off” enables the
de-equalization to be performed, according to the specic
curve of the source interfaced with the bit One HD.
Press BACK to go back to the previous step.
Press NEXT to go ahead with the setup procedure.
Press CANCEL to exit the program.
5
6
7

Audison bit One HD Specifications

General

Brand	Audison
Model	bit One HD
Category	Signal Processors
Language	English