Audison bit One HD User Manual

26
USER'S MANUAL
bit One HD /
8. Auto Input Switch
The automatic volume control for the auxiliary source (Aux - Optical 1/2)
can be activated through the Head Unit volume control, if it is provided
with an AUX input
(see section 5.4.3, 5.6.1; 8.3.5).
Press BACK to go back to the previous step.
Press NEXT to go ahead with the setup procedure.
Press SKIP to bypass the procedure.
Follow the instructions listed below:
- connect the AUX IN inputs of the source (Head Unit)
to the bit One HD RVA input.
- select the source AUX IN input (Head Unit).
- set the source volume to the maximum undistorted level.
As previously set as per point 2 of this procedure.
Press BACK to go back to the previous step.
Press NEXT to go ahead with the setup procedure.
Press CANCEL to exit the program.
When the procedure is completed:
Press BACK to go back to the previous step.
Press NEXT to go ahead with the setup procedure.
Press CANCEL to exit the program.
Window for the selection of the
loudspeakers available in the
system
9. Selection of the speakers available in the system
Speakers can be selected just by clicking on them.
If the left tweeter, left midrange or left woofer are selected, the software provides the ability to
automatically activate also the right tweeter, right midrange or right woofer.
Once the software is started, this choice will affect the dedicated crossover type.
E.g.: if on the rear system only the woofers are activated, the software will only
show a low-pass or band-pass lter as available.
If you want to use a coaxial system as rear channel, both tweeter and woofer
need to be selected and then you need to specify that a passive crossover is
connecting them, so the software will show a high-pass lter as available.
Press BACK to go back to the previous step.
Press NEXT to go ahead with the setup procedure.
Press CANCEL to exit the program.
From this point onwards a simulation of a system with the following
components will be used:
- 3-way Front active;
- 2-way Rear active;
- 2-way center passive;
- Stereo Sub;
The 13 output channels of the bit One HD will be used.
8
9
7

Audison bit One HD Specifications

General

Brand	Audison
Model	bit One HD
Category	Signal Processors
Language	English