AUMA SAEx 07.2 User Manual

Please state device type and our order number (see name plate) when ordering spare parts. Only original AUMA spare parts should be used.
Failure to use original spare parts voids the warranty and exempts AUMA from any liability. Representation of spare parts may slightly vary
from actual delivery.
TypeDesignationRef. no.TypeDesignationRef. no.
Output drive sleeve549.1Sub-assemblyBearing flange002.0
Sub-assemblyParallel key551.1Sub-assemblyHollow shaft003.0
Sub-assemblyMechanical position indicator553.0Sub-assemblyDrive shaft005.0
Sub-assemblySocket carrier for motor plug/socket con-
nector with cable harness
554.0Motor coupling005.1
Sub-assemblyPotentiometer as position transmitter556.0Manual drive coupling005.3
Sub-assemblyPotentiometer without slip clutch556.1Worm wheel006.0
Sub-assemblyHeater557.0Sub-assemblyManual gearing009.0
Sub-assemblyBlinker transmitter including pins at wires
(without impulse disc and insulation plate)
558.0Sub-assemblyTorque lever017.0
Sub-assemblyElectromechanical control unit with
switches, including torque switching heads
559.0–1Gear segment018.0
Sub-assemblyElectronic control unit with magnetic limit
and torque transmitter (MWG)
559.0–2Crown wheel019.0
Sub-assemblySwitch stack for direction OPEN560.0–1Sub-assemblyDrive pinion II for torque switching022.0
Sub-assemblySwitch stack for direction CLOSE560.0–2Sub-assemblyOutput drive wheel for limit switching023.0
Sub-assemblySwitch for limit/torque560.1Sub-assemblyDrive wheel for limit switching024.0
Switch case for direction OPEN560.2–1Sub-assemblyLocking plate025.0
Switch case for direction CLOSE560.2–2Sub-assemblyCable for protective earth058.0
Sub-assemblyRWG position transmitter566.0Sub-assemblyMotor (only for V... motors incl. ref. no.
079.0)
070.0
Sub-assemblyPotentiometer for RWG without slip clutch566.1Sub-assemblyPlanetary gearing for motor drive (only for
V... motors)
079.0
Sub-assemblyPosition transmitter board for RWG566.2Sub-assemblyReduction gearing155.0
SetCable set for RWG566.3Sub-assemblyCover500.0
Sub-assemblySlip clutch for potentiometer567.1Sub-assemblyPin carrier without pins502.0
Stem protection tube (without cap)568.1Sub-assemblyPin for controls505.0
Protective cap for stem protection tube568.2Sub-assemblyPin for motor506.0
V-seal568.3Sub-assemblyThreaded plug511.0
Threaded sleeve568.4Sub-assemblyOutput drive type A (without stem nut)514.0
Stem nut A (without thread)575.1Sub-assemblyAxial needle roller bearing514.1
Sub-assemblyMotor coupling on motor shaft583.0Radial seal for output drive type A514.2
Pin for motor coupling583.1Sub-assemblyOutput drive type D516.0
Sub-assemblyRetaining spring for motor coupling584.0Sub-assemblyOutput drive shaft D516.1
Sub-assemblyEWG position transmitter614.0Snap ring535.1
Blanking cover627.0Sub-assemblyScrew plug539.0
Ex plug/socket connector (KT, KM)628.0Sub-assemblyProtective earthing541.0
SetSeal kit, smallS1Sub-assemblyHandwheel with ball handle542.0
SetSeal kit, largeS2Sub-assemblyOutput drive type B (C/E) with output drive
sleeve
549.0
104
SAEx 07.2 – SAEx 16.2/SAREx 07.2 – SAREx 16.2 Control unit - electromechanical
Spare parts ACExC 01.2 Intrusive Modbus RTU

AUMA SAEx 07.2 Specifications

General

Brand	AUMA
Model	SAEx 07.2
Category	Controller
Language	English