Standard
RLL Instructions
5--76
Standard RLL Instructions
Table Instructions
DL105 PLC User Manual, 3rd Edition
In the example to the right, data is copied
from a Data Label Area to V--memory.
When X1 is on, the constant value (K4) is
loaded into the accumulator using the
Load instruction. This value specifies the
length of the table and is placed in the
second stack location after the next Load
and Load Label (LDLBL) instructions are
executed. The constant value (K0) is
loaded into the accumulator, specifying
the offset for the source and destination
data. It is placed in the first stack location
after the LDLBL instruction is executed.
The source address where data is being
copied from is loaded into the
accumulator using the LDLBL
instruction. The MOVMC instruction
specifies the destination starting location
and executes the copying of data from
the Data Label Area to V--memory.
DirectSOFT32
LD
K4
X1
Loadthevalue4intothe
accumulator specifying the
number of locations to be
copied.
LD
K0
Loadthevalue0intothe
accumulator specifying the
offset for source and
destination locations
LDLBL
K1
Loadthevalue1intothe
accumulator specifying the
DataLabelAreaK1asthe
starting address of the data
to be copied.
MOVMC
V2000
V2000 is the destination
starting address for the data
to be copied.
1234
CON
4532
CON
6151
CON
8845
CON
K
N
K
N
K
N
K
N
Handheld Programmer Keystrokes
V2001
4532
V2002
6151
V2003
8845
V2004
XXXX
S
S
S
S
V2000
1234
Data Label Area
Programmed
After the END
Instruction
DLBL K1
STR
$
SHFT
ANDST
L
3
D
SHFT
JMP
K
ENT
SHFT
ANDST
L
3
D
ANDST
L
1
B
ANDST
L
SHFT
ORST
M
AND
V
INST#
O
ORST
M
2
C
1
B
ENT
ENT
1
B
2
C
0
A
0
A
0
A
ENT
SHFT
ANDST
L
3
D
SHFT
JMP
K
0
A
ENT
4
E
Copy Data From a
Data Label Area to
V--Memory
To Next Page
