AutomationDirect DL105 - Page 348

Index--3
DL105 PLC User Manual, 3rd Edition
Mounting, Guidelines, 2--7
Move instruction, 5--74
Move Memory Cartridge instruction, 5--75
Multiply instruction, 5--64
N
Numbering Systems
BCD, G--5
Binary, G--2
Floating Point, G--6
Hexadecimal, G--3
Octal, G--4
Numerical Constant instruction, 5--84
O
Octal numbers, 4--20, 4--22
Or Double instruction, 5--55
Or If Equal instruction, 5--18
Or If Not Equal instruction, 5--18
Or Immediate instruction, 5--23
Or instruction, 5--10, 5--21, 5--54
Or Not Immediate instruction, 5--23
Or Not instruction, 5--10, 5--21
Or Out Immediate instruction, 5--25
Or Store instruction, 5--12
Out Double instruction, 5--49
Out Formatted instruction, 5--50
Out instruction, 5--49
P
Panel layout, 2--8
Part Numbers, 1--5
Password, 4--10, A--8
Pause instruction, 5--16
Pop instruction, 5--50
Positive Differential instruction, 5--15
Power wiring, 1--8
Presets, 3--8, 3--10
Program control instructions, 5--78
Program mode, 4--12
Programming, concepts, 1--11
Programming methods, 1--8
Q
Quadrature counter, 3--17
Quick start, 1--6
R
Registration profile, 3--29, 3--33
Relay wiring, 2--22, 2--24
Reset instruction, 5--15
Retentive memory, 4--9
Run mode, 4--12
Run time edits, 8--14
S
Safety, panel design specifications, 2--4
Safety guidelines, 2--2
Scan time, 4--18
Scratchpad memory, 1--9, 4--9
Set instruction, 5--15
Shift Left instruction, 5--67
Shift Right instruction, 5--68
Sinking / sourcing I/O, 2--20
Special relays, 4--13, 4--25, D--2, E--2
Specifications
CPU, 4--3
environmental, 2--9
F1--130AA, 2--38
F1--130AD, 2--34
F1--130DA, 2--40
F1--130DD, 2--36
F1--130DD--D, 2--44
F1--130DR, 2--32
F1--130DR--D, 2--42
motion profiles, 3--26
panel design, 2--8
Stack, 5--7
Stage Counter instruction, 5--35
Stage instructions, 7--19