2 Installation
28 © Copyright Reserved Autonics Co., Ltd.
2.3 Battery replacement
Please contact our service center to replace LP battery.
It may cause an explosion or a fire when using improper battery.
2.4 Caution for using
Use communication cable after checking whether there is break or short.
Please install power switch or circuit-breaker in order to cut power supply off.
Separate this unit from high voltage line, power line to avoid inductive noise.
Do not use this product at below places where causes serious malfunction.
① Place where there is severe vibration or impact.
② Place where dust exists, or corrosion causing environments.
③ Place where strong field or electric noise are generated.
④ Place where temperature or humidity is beyond the specification.
⑤ Place where strong alkalis or vibration or impact.
⑥ Place where there are direct ray of sun.
Installation environment
① It shall be used indoor.
② Altitude Max. 2,000m
③ Pollution Degree 2
④ Installation Category Ⅱ
It may cause malfunction if above instructions are not followed.
Do not install this product as below places.
A place where ambient temperature is outside the range of 0°C to 50°C.
A place where ambient humidity is outside the range of 35% to 85% RH.
A place where sudden temperature change occurs frequently (so dew may form on the
product).
A place where the product is not likely to be protected from direct sunlight and rain.
A place exposed to dust or metallic fragments.
A place exposed to corrosive or flammable gas.
A place where continuous impact and vibration may occur.
A place directly exposed to noise sources from high voltage transformers, current
transformers, main power cables, power systems and frequency converters.
Pay attention to the following when installed:
Do not let conductive substances from panel cut-out or wiring ducts enter into LP.
Make sure to allow enough space to handle the LP.
Secure enough space to maintain inside temperature and humidity of the panel when you mount
LP.
To Next Page
Loading...