Autonics LP-S044 - PLC Setting

6 System Screen
© Copyright Reserved Autonics Co., Ltd. 51
6.4.2 PLC setting
This menu displays connected device to RS232C, RS422 port of LP-S044. You can designate
station and connected port by each channel.
No. Function and operation
①CH1 configuration
line
Displays connected device and connect port for CH1.
Touch this to select one from downloaded protocol in EDITOR,
PRINTER, BARCODE and designate connect port. (Select RS232C or
RS422 or depending on CH2 setting, CH1 may be changed as the
other).
Depending on the setting, CH1 may be changed as ‘No Use’.
②CH1 PLC protocol
Displays PLC protocol of CH1
③CH1connect port
Displays connect port of CH1
④CH2 configuration
line
Displays connected device and connect port for CH2.
Touch this to select one from downloaded protocol in EDITOR,
PRINTER, BARCODE, MONITOR protocol and designate connect port.
(Select one of RS232C or RS422 or depending on CH1 setting, CH2
may be changed as the other.)
If CH1 is SLAVE, MONITOR does not appear.
⑤CH2 PLC protocol
Displays PLC protocol of CH2
⑥CH2 connect port
Displays connect port of CH2
⑦LP station
configuration touch
key
Touch this and input key pad for decimal (DEC) appears. It is available
the range from 0 to 31.
⑧ Configuration
touch key by each
channel
Touch this and input key pad for decimal (DEC) appears. It is available
the range from 0 to 255.