Safety Precautions
vi © Copyright Reserved Autonics Co., Ltd.
Safety Precautions
Following these safety precautions will ensure the safe and proper use of the product and
help prevent accidents and minimize hazards.
Safety precautions are categorized as Warnings and Cautions, as defined below:
Warning
Cases that may cause serious injury or fatal accident if
instructions are not followed.
Caution
Cases that may cause minor injury or product damage if
instructions are not followed.
In case of using this unit with machinery (Ex: nuclear power control, medical equipment,
ship, vehicle, train, airplane, combustion apparatus, safety device, crime/disaster prevention
equipment, etc) which may cause damages to human life or property, it is required to install
fail-safe device.
It may cause a fire, human injury or property loss.
Do not use the Logic Panel where serious physical damage or production halt can be
caused.
It may cause a fire, human injury or property loss.
In case using the Logic Panel touch switch for controlling, do not use the switch as an
emergency switches or those related to safety that may cause physical injury or property
damage in the event of a malfunction..
It may cause a fire, human injury or property loss.
In the event of LP defect or malfunction in the Logic Panel, an alternative circuit must be
constructed on the exterior.
It may cause a fire, human injury or property loss.
Construct an emergency power-off circuit, safety circuit, or interlock circuit on the exterior of
the Logic Panel.
It may cause a fire, human injury or property loss.
If an error occurs on the watchdog timer of the Logic Panel, the logic program will shut
down automatically, so an alternative circuit must be constructed on the exterior.
It may cause a fire, human injury or property loss.
The overall system operation may malfunction due to an input error resulting from a failure
in input signal detection; so an alternative circuit must be constructed on the exterior.
It may cause a fire, human injury or property loss.
For output signals that may cause a serious accident if the output section is damaged, a
detection circuit and alternative circuit must be constructed on the exterior.
It may cause a fire, human injury or property loss
In case controlling other devices through Logic Panel communication, and there is a
possibility of malfunction due to communication error, an alternative circuit must be
constructed.
It may cause a fire, human injury or property loss.
To Next Page
Loading...
General