Autonics LP-S044 - Interrupt

To Next Page

To Previous Page

6 System Screen

6.7.2 Interrupt

This menu is for displaying the set interrupt at SmartStudio.

For interrupt information, refer to ‘SmartStudio user manual’.

 Interrupt is not set.

 Interrupt is set at SmartStudio.

No. Function and operation

①

Displays the set interrupt type of X00-X0F. (No Int, Falling, Rising)

②

Saves the set value at the device by 2 bit 2 WORD in order.

This example is that each interrupt set value is mapping to inner device.

(In case of setting inner device as M0100)

From the logic to change this inner device value on ladder program, it can control filter value.

To use inner device, to control interrupt value are same as using filter’s.