Autonics LP-S044 - Connect with GP Editor

To Next Page

To Previous Page

4 System Organization

4.7 Connect with GP Editor

Communication between PC and LP-S044 is available with serial communication.

Setting method is as below.

1st Enter system setting menu.

Touch left-upper point as default position of system setting menu.

2nd Select [SET ENVIRONMENT]- [PLC SETTING]..

3rd Check that CH2 configuraiton is as‘EDITOR’, and connected connection port with LP-

S044 is as ‘RS232C’.

If the configuration is not as ‘EDITOR’, touch (PROTOCOL) part and cofigure as

‘EDITOR’.

Touch this, it rotates in order as EDITOR → PRINTER → BARCODE →

MONITOR.

Touch (PORT) area to configure the connection port of LP-S044.

Touch this, it rotates in order as [RS422] and [RS232C].

To check baud rate, data bit, stop bit, parity, etc, touch the desired channel ‘CH1’ or ‘CH2’.

It is able to download and upload GP Editor content to LP-S044 only when the baud rate

between GP Editor and LP-S044 are configured as same.

4th Touch [Menu], current setting values are saved and it returns to previous menu.

Touch [Exit], current setting values are saved and it returns to user screen after

exiting system setting menu.