Autonics LP-S044 User Manual

Safety Precautions
© Copyright Reserved Autonics Co., Ltd. vii
 When switching the mode to RUN mode, make sure that supply power to LP, I/O unit and
load first. If not, output error or miss-operation may cause.
It may cause a fire, human injury or property loss.
 Do not use the product in an area or an environment not specified in the manual.
It may cause a fire, human injury or property loss.
 Do not connect, inspect or repair this unit when power is on.
It may cause electric shock or a fire.
 Do not disassemble the product. Please contact us if it is required.
It may cause electric shock or a fire.
 Please use the rectified power with insulation trans.
It may cause electric shock or a fire.
 Do not use the power to the exceeded rated voltage.
It may cause electric shock or a fire.
 This product uses lithium battery, do not disassemble or burn up it.
It may cause an explosion or a fire.
 Wire properly after checking power terminal polarity.
It may cause a fire or a malfunction.
 Please read all notes and cautions related to installation and wiring in the manual.
It may cause electric shock or malfunction.
 Make sure the ground wire of Logic Panel is wired separately from the ground wires of other
devices. Ground resistance must be less than 100Ω, and a lead wire of which sectional
area is over 1.25mm
2
should be used.
It may cause electric shock or malfunction.
 When connecting Logic Panel ports with communication port and constructing input/output,
check the pin number and terminal block before connecting.
It may cause a fire or malfunction.
 Please tighten bolt on terminal block with specified tightening torque.
It may cause a short circuit, fire or a malfunction.
 Do not press the surface of the touch panel with sharp or hard objects.
The touch panel may be damaged.
 Keep Logic Panel at the specified temperature.
If stored at a temperature beyond the specification, LCD may be broken.
 Do not inflow dust or wire dregs into the unit.
It may cause a fire or a malfunction.
 Do not use in an area with excessive humidity or temperature.
It may shorten the life cycle of this unit or cause a malfunction.
 Do not close ventilating opening of this product.
It may cause a malfunction due to increased inner temperature.
 Keep the product out of direct sunlight or excessive dust.
It may shorten the life cycle of this unit or cause a malfunction..

Autonics LP-S044 Specifications

General

Brand	Autonics
Model	LP-S044
Category	Monitor
Language	English