AVANT 528 - Working with Attachments Safely; Attachment Requirements and Compatibility; Importance of Attachment Manuals

39
500 Series Operating instructions
Working with attachments
Requirements for attachments
Any attachment mounted on the loader must meet applicable safety and technical standards and requirements. An
attachment that is not specically designed for the loader may cause unsafe operation; make sure that your Avant
loader model is specically listed in the operator’s manual of the attachment. Some attachments may require the use
of special protective guards or personal safety equipment.
• Read Operator’s Manual of the attachment before you begin to use any attachment.
• Make sure that the attachment is compatible with the loader. Contact your Avant dealer if
necessary.
• Make sure that the attachment is connected properly on the attachment coupling plate, and
that it is being used in accordance with the instructions in the Operator’s Manual. Follow the
instructions regarding personal protective equipment and safety distances.
• Put the attachment down on the ground and switch off the loader before leaving driver’s
seat. Familiarize yourself with the operation and stopping of the attachment at a safe place.
• Follow the service instructions.
Check the max. allowed hydraulic oil ow for the attachment. Adjust the hydraulic output of the
loader so, that the hydraulic oil ow is suitable for the work and the attachment. See page 23
for more information.
Manuals of attachments
Attachments can create signicant risks that are not covered by
this Operator’s manual of the loader.
Make sure you have all attachment manuals available. Misuse of an
attachment can cause serious injuries or death.
Each attachment is accompanied by its own respective Operator’s
Manual. The manual contains important information related to safety,
installation, use and maintenance.