The handset restarts and after a few seconds, the system displays a message "Saving
settings. Do not remove phone from charger". The charger LED changes to
slow orange flashing. It may take several minutes.
Important:
If the old handset cannot communicate with the charger, put the new handset in the
charger to restore its settings (the handset’s IPDI). If this step is not performed, the
new handset must be sent for service. The settings of the old handset can be
transferred to the new handset by using PDM/Device Manager.
6. When the system displays the message "Please insert new phone in charger",
replace the old handset with the new handset.
The system displays the message "Restoring settings".
Important:
Do not remove the handset while the message "Restoring settings" is
displayed.
7. When the system displays the message
"Phone successfully replaced. Please
remove phone to restart", remove the handset from the charger.
The handset automatically restarts.
LED indications during easy replacement
The following table shows the LED indications that are used for the charger during the easy
replacement procedure.
LED indication
Description
Orange, flashing (1 000 ms on, 1 000 ms off) File transfer during Easy Replacement.
Orange, flashing (100 ms on, 800 ms off) “Change phone” indication during Easy
Replacement.
Red, flashing (100 ms on, 800 ms off) Error indication during Easy Replacement. Put back
old handset in charger.
Red, flashing (900 ms on, 100 ms off) Error during Easy Replacement. Service needed for
both handsets.
Maintenance
November 2021 Using Avaya Wireless Handset 3730 with Communication Manager and IP Office 74
Comments on this document? infodev@avaya.com
To Next Page
Loading...
