BCM50 Hardware & Installation
NN40011-002 Issue 1.2 BCM50 Rls 6.0 13
Flow Chart
The flow chart below describes the BCM50 installation process.
Install the BCM50 in a
rack: refer to the
Installing the BCM50
in an Equipment Rack
section of this guide.
Where is the BCM50 being installed?
Apply the supplied
rubber feet.
Install wall mount
bracket: refer to the
Installing the BCM50
Wall Mount Bracket
section of this guide.
Ensure the Media Bay Module Dipswitches
are set correctly: refer to the Media Bay
Module Dipswitches section of this guide.
Fit the Media Bay Module: refer to the
Installing a Media Bay Module into the
Expansion Unit section of this guide.
Connect the MBM to the Main Unit: refer to
the Expansion Unit Connections section
of this guide.
Power up the BCM: refer to the BCM50
Power Supply and Power Up Procedure
sections of this guide.
To Next Page
Loading...
