BCM50 Hardware & Installation
NN40011-002 Issue 1.2 BCM50 Rls 6.0 61
Replacing the Cover of the Main Unit
1. Attach one end of a grounding strap to your wrist and the other end to a
grounded metal surface.
2. There are a number of L shaped connectors that will connect into the
main chassis of the BCM50.
3. Place the top of the case on top of the main unit case. Make sure the
side edges of the case are aligned and the front of the top is back
about 1 cm (3/8 in.).
4. Slide the top of the case forward until it clicks in place.
5. Turn the main unit over so you can access the screws holes on the
bottom of the unit.
6. Insert the three case screws in the back of the unit and tighten them.
To Next Page
Loading...
