BCM50 Hardware & Installation
NN40011-002 Issue 1.2 BCM50 Rls 6.0 77
2. Click on the Additional Information tab, and make a note of the CSC
Hardware version.
3. If the CSC hardware is version 1, please note the steps indicated in the
BCM50 Upgrade Flow Charts section of this guide. The specific steps
relating to CSC hardware version 1 models involve ensuring the
BCM50 Rls 3.0 or 5.0 Factory Image is applied before upgrading to
BCM50 Rls 6.0.
Checking the Time Zone is Set Correctly
Before any upgrade is performed, you should check that the Time Zone has
been changed from the initial default setting, to the Time Zone of your locality.
If the Time Zone is still set to Factory Default, it will not be possible to apply
the upgrade files.
Use the following procedure to check the Time Zone setting.
1. In the Element Manager Configuration tab, open the System folder
and select Date and Time.
To Next Page
Loading...
