Avaya BCM50 - Installing a BCM50 Expansion Unit; Supported Media Bay Modules

BCM50 Hardware & Installation
NN40011-002 Issue 1.2 BCM50 Rls 6.0 23
Installing a BCM50 Expansion Unit
Adding a BCM50 Expansion Unit increases the capacity of the BCM50 system
by providing a method of adding a media bay module (MBM). Each MBM you
add increases the number of trunks or extensions that you can connect to the
BCM50 system.
 There are a maximum of 2 Expansion Units allowed
 Each Expansion Unit can support 1 Media Bay Module
 There is no bus sharing allowed (as on the BCM200/400)
Supported Media Bay Modules
The following Media Bay Modules are supported on the BCM50:
 Digital Trunk Modules:
o DTM (digital trunk module)
o BRI (ISDN Basic Rate trunk module)
 Analog Trunk Modules
o CTM4/8 (4/8-port analog CLID trunk module)
o GATM4/8 (global 4/8-port analog trunk module)
o ADID4/8 (4/8-port analog direct inward dial)
 Digital Station Modules
o DSM16(+)/32(+) (16/32-port digital station module)
 Analog Station Modules
o ASM8/8+ (8-port analog station interface)
o GASM8 (global 8-port analog station interface)
 Combination Modules
o 4/8x16 Combo (4/8 analog trunks, 16 digital stations,
combination of CTM4/8 & DSM16)
o G4/8x16 Combo (global 4/8 analog trunks, 16 digital stations,
combination of GATM4/8 & DSM16)
 Special Modules
o R2MFC