Note: This does not apply to the DHCP configured on the router card of the
BCM50(b)e or BCM50(b)a models. If the DHCP service is enabled on the
router card of these models, it should not be affected by the upgrade.
Use the following procedure to check the DHCP service setting for the BCM.
1. In the Element Manager Configuration tab, open the Data Services
folder and select DHCP Service.
2. Select one of the available modes (i.e. not Enabled – Automatic).
Applying the Keycode File
A keycode file containing the upgrade authorisation entitlement (upgrade to
Rls 6.0 or first upgrade to Rls 3.0 if upgrading from Rls 1.0) should be applied
to the BCM before applying the upgrade files.
When you have obtained the keycode file(s) containing the appropriate
upgrade entitlement, apply the keycode using the following procedure.
To Next Page
Loading...
