BCM50 Hardware & Installation
NN40011-002 Issue 1.2 BCM50 Rls 6.0 29
Media Bay Module Dipswitches
Each media bay module (MBM) has a set of dipswitches on the back or
underside of the MBM
If you are installing a DTM, BRIM, CTM4/8, ADID4/8, 4x16, DSM16/32(+), or
ASM8, ensure that all the switches are on. This is the default setting for the
MBM switches.
The exceptions to this are the GASM (Analog extensions), GATM (Analog
Lines), and G4/8x16 modules. The settings below refer to the switches on the
right hand side of the GASM Media Bay Module. For the dip switches on the
left side, set all the switches to on.
GASM right hand side dipswitch settings (switch 1-3)
To Next Page
Loading...
