BCM50 Hardware & Installation
44 NN40011-002 Issue 1.2 BCM50 Rls 6.0
8. Plug the UPS power cord into the ac power source (wall outlet).
Power Up Procedure
The BCM50 takes approximately four to five minutes to boot up. There is no
on/off switch on the system.
1. Plug the power supply cord into the BCM50 unit, with the power supply
cable plugged into the wall outlet.
2. The BCM will start the boot up process.
3. On BCM50 boot-up the status lights will display various states
LED States
This section describes the Power and Status LED indication.
To Next Page
Loading...
