BCM50 Hardware & Installation
NN40011-002 Issue 1.2 BCM50 Rls 6.0 63
Connecting Cables to the Wiring Field Card
If you are using the optional wiring field card (WFC), use this procedure to
connect the cables to WFC.
1. Plug the RJ21-end of the cable assembly into the telephony connector.
2. Plug the other end of the cable assembly into the WFC header.
3. The cable locks in place.
4. Remove the terminal block from the WFC.
5. Slide a small flat screwdriver into the rectangular opening at the back of
the terminal block.
6. Pry the terminal block such that the top rotates forward and the block
comes free.
7. You make the connections to the terminal block while it is removed
from the header.
8. Use a small slotted screwdriver to unscrew the wire hole screws on top
of the terminal block.
9. Insert the bare wire ends (¼‖ or 6mm) in the appropriate holes on the
sides of the terminal block.
10. Tighten the screws to hold the wires in place.
11. Re-install the terminal block on the header of the WFC.
12. Connect the remaining wires (digital telephones, analog telephones,
and analog trunks) to the WFC.
13. The 8-pin modular jacks on the WFC accept RJ45 or RJ11 modular
plugs.
14. Connect cables to the BCM50 as required.
To Next Page
Loading...
