BCM50 Hardware & Installation
NN40011-002 Issue 1.2 BCM50 Rls 6.0 57
4. Disconnect all cables.
5. Follow the procedure for replacing the hard drive.
6. Stop at disconnecting the SATA and power cables.
7. Disconnect fan power cable.
8. Lift the fan out.
9. No screws to remove.
10. Insert new fan in the fan slot.
11. Ensure the label faces the back of the unit.
12. Insert fan power cable.
13. Replace the hard drive/bracket into original location.
14. Attach case and insert case screws.
15. Insert cables and power up.
To Next Page
Loading...
