FIRMWARE VERSION 1.0.5.2 E129 SIP DESKPHONE USER MANUAL Page 41 of
60
DHCP Vendor Class ID
(Option 60)
Used by clients and servers to exchange vendor class ID.
Allow DHCP Option 120 to
override SIP Server
Enables DHCP Option 120 from local server to override the SIP Server
on the phone. The default setting is "No".
Enter the PPPoE account ID.
Enter the PPPoE Password.
Enter the PPPoE Service Name.
Enter the IP address when static IP is used.
Enter the Subnet Mask when static IP is used for IPv4.
Enter the Default Gateway when static IP is used for IPv4.
Enter the DNS Server 1 when static IP is used for IPv4.
Enter the DNS Server 2 when static IP is used for IPv4.
Enter the Preferred DNS Server for IPv4.
Allows users to configure the appropriate network settings on the phone
to obtain IPv6 address. Users could select "Auto-configured" or
"Statically configured" for the IPv6 address type.
Enter the static IPv6 address when Full Static is used in "Statically
configured" IPv6 address type.
Enter the IPv6 prefix length when Full Static is used in "Statically
configured" IPv6 address type.
Enter the IPv6 Prefix (64 bits) when Prefix Static is used in "Statically
configured" IPv6 address type.
Enter the DNS Server 1 for IPv6.
Enter the DNS Server 2 for IPv6.
Enter the Preferred DNS Server for IPv6.
Allows the user to set 802.1x mode on the phone. The default value is
disabled.
Enter the Identity for the 802.1x mode (EAP-MD5,
EAP-PEAPv0/MSCHAPv2).
802.1x Secret/Private Key
Password
Enter the Secret/Private Key Password for 802.1x mode. It won't be
displayed for security protection purpose.
Upload the CA Certificate file for 802.1x mode.
802.1x Client Certificate
Upload the Client Certificate for 802.1x mode.
Specifies the HTTP proxy URL for the phone to send packets to. The
proxy server will act as an intermediary to route the packets to the