FIRMWARE VERSION 1.0.5.2 E129 SIP DESKPHONE USER MANUAL Page 40 of
60
default setting is "Adaptive".
Selects Low, Medium, or High based on network conditions. The default
setting is "Medium".
Configures the conference URI when using Broadsoft N-way calling
feature.
Configures DND feature code to turn on DND.
Configures DND feature code to turn off DND.
Controls whether the Privacy Header will present in the SIP INVITE
message or not. The default setting is "default", which is when "Huawei
IMS" special feature is on, the Privacy Header will not show in INVITE. If
set to "Yes", the Privacy Header will always show in INVITE. If set to
"No", the Privacy Header will not show in INVITE.
Use P-Preferred-Identity
Header
Controls whether the P-Preferred-Identity Header will present in the SIP
INVITE message or not. The default setting is "default", which is when
"Huawei IMS" special feature is on, the P-Preferred-Identity Header will
not show in INVITE. If set to "Yes", the P-Preferred-Identity Header will
always show in INVITE. If set to "No", the P-Preferred-Identity Header
will not show in INVITE.
Different soft switch vendors have special requirements. Therefore users
may need select special features to meet these requirements. Users can
choose from Standard, Nortel MCS, Broadsoft, CBCOM, RNK, Sylantro
or Huawei IMS depending on the server type. The default setting is
"Standard".
SETTINGS/BASIC SETTINGS PAGE
Allows the administrator to set the password for user-level web GUI
access. This field is case sensitive with a maximum length of 30
characters.
Confirms the end user password field to be the same as above.
Selects Prefer IPv4 or Prefer IPv6.
Allows users to configure the appropriate network settings on the phone
to obtain IPv4 address. Users could select "DHCP", "Static IP" or
"PPPoE". By default, it is set to "DHCP".
DHCP Host name (Option 12)
Specifies the name of the client. This field is optional but may be
required by some Internet Service Providers.
To Next Page
Loading...
