Avaya E129 - Page 49

FIRMWARE VERSION 1.0.5.2 E129 SIP DESKPHONE USER MANUAL Page 50 of
60
Up to three cadences are supported.
Disable Call-Waiting
Disables the call waiting feature. The default setting is "No".
Disable Call-Waiting Tone
Disables the call waiting tone when call waiting is on. The default setting
is "No".
Disable Direct IP Calls
Disables Direct IP Call. The default setting is "No".
Use Quick IP-Call mode
When set to "Yes", users can dial an IP address under the same
LAN/VPN segment by entering the last octet in the IP address. To dial
quick IP call, off hook the phone and dial #XXX (X is 0-9 and XXX
<=255), phone will make direct IP call to aaa.bbb.ccc.XXX where
aaa.bbb.ccc comes from the local IP address REGARDLESS of subnet
mask. #XX or #X are also valid so leading 0 is not required (but OK). No
SIP server is required to make quick IP call. The default setting is "No".
Disable Conference
Disables the Conference function. The default setting is "No".
Disable Transfer
Disables the Transfer function. The default setting is "No".
Auto-Attended Transfer
If set to "Yes", the phone will use attended transfer by default. The
default setting is "No".
In-call dial number on pressing
transfer key
Configures the number for the phone to dial as DTMF during the call
using TRANSFER button.
Configuration via Keypad Menu
Configures the access control for the users to configure from keypad
Menu. There are three different options:
 Unrestricted. All the options can be accessed in keypad Menu.
 Basic settings only. The CONFIG option will not display for users
to access in keypad Menu.
 Constraint Mode. CONFIG, FACTORY FUNCTIONS and
NETWORK options will not display for users to access in keypad
menu.
Enable STAR key Keypad
locking
If set to "Yes", the keypad can be locked by pressing and holding the
STAR * key for about 4 seconds. A lock icon will show indicating the
keypad is locked. The default setting is "Yes".
Note:
When the keypad is locked, users would need press and hold the STAR
* key for about 4 seconds again and then enter the password to unlock
it.
Password to lock/unlock
Configures the password to lock/unlock the keypad. The password field
allows number with up to 32 characters.
Offhook timeout
If configured, when the phone is on hook, it will go off hook after the