Putting a conference call on hold and resuming a call
About this task
Use this procedure to put a conference participant on hold, while other participants continue the
conference call.
Procedure
1. Press Hold soft key or Hold button during a conference call.
2. Do one of the following:
• Press Resume soft key or Hold button.
• Select the call appearance to resume the conference call.
Dropping or Disconnecting the last participant from a
conference call
About this task
Depending on the configuration made by your administrator, you can disconnect the last
participant who joined the conference call. After you disconnect the last participant, you cannot
disconnect other participants. You can disconnect a participant again after you add another
participant to the conference call.
Before you begin
Ensure that the administrator activates the feature. Contact your administrator for details.
Procedure
1. From the phone screen, select your active conference call.
You will see the More soft key.
2. Press More > Drop when the conference is active.
Result
The participant who was added last gets disconnected from the conference.
Related links
Adding a participant to no hold conference on page 93
Viewing the details of a conference
Putting a conference call on hold and resuming a call
April 2021 Using Avaya J159 SIP IP Phone in Avaya Aura
®
63
Comments on this document? infodev@avaya.com
To Next Page
Loading...
