Basic migration steps
Issue 2.1 June 2006 383
Migrating from a DEFINITY Server CSI in a CMC to an
S8400 Media Server using Xmodem
Use these procedures to migrate from an existing DEFINITY Server CSI in a Compact Modular
Cabinet (CMC) with a linear flash to an Avaya S8400 Media Server that uses Xmodem.
When you migrate an existing DEFINITY Server CSI in a CMC, you use one TN8412AP S8400
IP Interface (SIPI) circuit pack to control the one port network (PN). You must replace the
TN2182 Tone Clock circuit pack with the SIPI circuit pack. You also must replace the TN798B
Processor circuit pack.
This migration affects service.
Basic migration steps
● Replace the tone clock circuit pack with the TN8412AP S8400 IP Interface (SIPI) circuit
pack. For more information, see Quick Start for Hardware Migration: Avaya S8400 Media
Server in an Avaya CMC1 or G600 Media Gateway (03-300706).
● Replace the processor circuit pack with the TN8400AP Media Server circuit pack. For
more information, see Quick Start for Hardware Migration: Avaya S8400 Media Server in
an Avaya CMC1 or G600 Media Gateway (03-300706).
● Enable control of the SIPI and switch control to the media server
● Complete the postmigration administration
Migration paths
Avaya supports the following migrations of a DEFINITY Server CSI in a CMC to the S8400
Media Server configuration:
● DEFINITY Release 8 and later
To migrate, you can use the existing translations. One supported method to move translations
from legacy systems is to:
1. Copy the translations using Xmodem.
2. Copy the translation files to the S8400 Media Server.
To Next Page
Loading...
Need help?
General
