Migrating from an IP600 or S8100 to an S8400 Media Server using ftp
420 Upgrading, Migrating, and Converting Media Servers and Gateways
Presite migration checklist
Before you go on site, complete the following tasks:
On site migration checklist
When you are on site, complete the following tasks before you start the migration:
9
Task Description
Verify that the voice network,
dial plan, and E911 for remote
locations were redesigned.
Perform this task only if applicable.
Verify that all existing circuit
packs work with the new
system.
Check the Minimum Vintage Table. Go to the
Hardware and Software Compatibility Matrix at ftp//
ftp.avaya.com/incoming/Up1cku9/tsoweb/media/
minhardwarevintages.pdf.
Replace any TN799B/C C-LAN
circuit packs.
Replace with the TN799DP circuit pack.
Replace the 259A adapter and
the CAT3 cable.
Replace with the cable extender adapter with
Comcode 848525887 and the CAT5 or better cable.
Replace TN570 EI circuit packs. Replace with TN570B vintage 7 or later circuit packs.
9
Task Description
Verify that you have the
correct cables for the
TN8412AP S8400 Internet
Protocol Interface (SIPI)
circuit packs.
The cables must be labeled and run from the control
hardware rack to the port networks. Appropriate
connectivity must be provided.
Verify that you have all
necessary equipment
onsite.
For the list of required hardware, see Installing and
Configuring the Avaya S8400 Media Server
(03-300678).
To Next Page
Loading...
Need help?
General
