EasyManuals Logo

Avaya S8710 User Manual

Avaya S8710
1262 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #561 background imageLoading...
Page #561 background image
Migrating translations
Issue 2.1 June 2006 561
Administering the IPSIs
To administer the IPSIs:
1. Type change system-parameters ipserver-interface. Press Enter
2. Verify that the Primary Control Subnet Address field is correct.
The subnet address must match the most significant three octets (the first three groups of
digits in the subnet address) of the server IP address that is listed on the control network
entry from the completed Electronic Preinstallation Worksheet (EPW).
An asterisk (*) to the right of the Subnet Address field means that although a subnet
address displays, this address is incorrect. Avaya Communication Manager does not have
the subnet information. After you verify the information shown on the screen, submit this
form with or without changes to update the Communication Manager with the correct subnet
information.
!
CAUTION:
CAUTION: If the information in the Primary Control Subnet Address field is incorrect, you
must change the information on the media server. Use the Maintenance Web
Interface. Under Server Configuration and Upgrades, click Configure Server to
change the media server configuration. Then continue with step 3 of this
procedure.
3. Verify that the Switch Identifier field is set correctly for this installation. You must enter the
correct switch identifier here before you administer the TN2312 IPSI circuit packs.
4. Verify that the IPSI Control of Port Networks field is set to disabled.
5. Press Enter.
Adding IPSI translations to Communication Manager
To add IPSI translations to Communication Manager:
1. Type add ipserver-interface 1. Press Enter to add the IPSI circuit pack information.
2. If you use static addressing, in the Host field, type the IP address for the IPSI that is in the
port network listed in the Location field.
3. Verify that the IP Control? field is set to y.
4. Verify that all the other fields are populated.
5. Press Enter to put the changes into effect.
6. Repeat Steps 1 through 5 for each IPSI.

Table of Contents

Other manuals for Avaya S8710

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Avaya S8710 and is the answer not in the manual?

Avaya S8710 Specifications

General IconGeneral
BrandAvaya
ModelS8710
CategoryServer
LanguageEnglish

Related product manuals