(Optional) Installing the NPT Mount Adapter
CAUTION — The dome camera must be mounted as instructed below or problems with moisture
may arise and will not be covered by the dome camera warranty.
If you are installing the H5A Multisensor camera with an NPT adapter (NPTA-1001), the dome camera must
be mounted on a 1-1/2” NPT female threaded wall or ceiling mounting bracket. The mounting bracket is not
included in the camera package.
Note: The NPT pipe and NPT-female to NPT-female adapter are not supplied by Avigilon and
should be sourced separately. However, if you are using the NPT adapter (NPTA-1001), the lock
nut is included.
1.1. Wrap the thread of the NPT adapter with the supplied thread-sealing tape to create a water tight seal
around the camera connection. There should be three to five turns around the entire threaded
surface.
When applying the thread-sealing tape, wrap the tape clockwise.
(Optional) Installing the NPT Mount Adapter 20
To Next Page
Loading...
