Avigilon 9C-H5A-3MH - Installing the H5 A Multisensor Camera Base to an In-Ceiling Mount; Aiming the H5 A Multisensor Camera

Image Rate page of the camera's web interface. To connect an H5A Multisensor camera to an ACC
system, be sure to set the Format to H.264 or to upgrade the ACC software to v6.12.2 or later.
Installing the H5A Multisensor Camera Base to an In-Ceiling Mount
After the cable connections have been made, mount the H5A Multisensor camera base into the in-ceiling
mount adapter.
1. Inspect the PoE switch setting in the camera base to verify it is set correctly for your installation. The
"B" position is the default position that is compatible with the 802.3bt standard. The "A" position
should be used for legacy HPoE injectors PD-9501G, PD-9501GR, and PD-9601G. For more
information, see the Overview on page8 section.
2. (Recommended) Attach a safety lanyard from the in-ceiling mount adapter to the lanyard anchor on
the camera base to prevent the camera from falling. See Connecting Cables on page55.
3. Push the camera module into the in-ceiling mounting adapter so that the 3 setscrews pass through
the 3 slots (a). In one smooth motion, push the camera module up through the 3 slots (a), twist
clockwise (b), and push up again so the 3 setscrews are positioned at the 3 screw holes (c).
4. Use a screwdriver to turn the 3 setscrews clockwise by 90° and secure the camera into the in-ceiling
mount adapter (d).
Aiming the H5A Multisensor Camera
Reference the camera's live stream as you aim the camera.
Installing the H5A Multisensor Camera Base to an In-Ceiling Mount 61