6. Connect the network cable to the Ethernet port (1) and the external power/audio/digital I/O cable to its
connector (2). Secure the connections by turning them clockwise (3). For information about using
redundant power with seamless failover, refer to Seamless Failover .
The Link LED will turn on once a network link has been established.
7. Check that the Connection Status LED indicator indicates the correct state. For more information, see
Connection Status LED Indicator
on page71.
(Optional) Configuring microSD Card Storage
To use the camera's SD card storage feature, you must insert one or two microSD cards into the card slot.
It is recommended that the microSD card have a write speed of class 10 or better. If the microSD card does
not meet the recommended write speed, the recording performance may suffer and result in the loss of
frames or footage.
1. Insert one or two microSD cards into the camera.
Note: The camera will record video to both SD card slots simultaneously if two SD cards are
inserted. The total storage capacity of the system is the combined storage capacity of each
of the individual cards.
(Optional) Configuring microSD Card Storage 26
To Next Page
Loading...
