1. Use the mounting template to cut a hole in the mounting surface.
2. Remove the mounting template and pull the required cables through the mounting hole. If you are
using a conduit pipe to route the cables, see
(Optional) Attaching the Conduit Cable Entry Cover for
Plenum Installations
below.
(Optional) Attaching the Conduit Cable Entry Cover for Plenum
Installations
If you are installing the H5A Multisensor camera into a plenum space, use a conduit pipe and the cable entry
cover to route the cables through the in-ceiling adapter.
1. Route the required cables through a conduit pipe at the installation location.
2. Attach a conduit connector to the cable entry cover. Install the conduit and its fitting as instructed by
the manufacturer. Make sure the conduit is securely fastened to the cable entry cover.
3. Pull the required cables through the conduit and cable entry cover, then through the cable entry hole
(Optional) Attaching the Conduit Cable Entry Cover for Plenum Installations 52
To Next Page
Loading...
