Surface Mount Installation
Camera Package Contents
The H5A Multisensor camera has a variety of different mounting, dome cover, camera and accessory
options. The components for each H5A Multisensor camera will arrive in a camera package, a dome cover
package, a mounting adapter package, and an optional IR Ring package.
Ensure the camera package contains the following:
l
Avigilon H5A Multisensor Camera module. A 3- or 4-sensor camera module with 3 MP, 5 MP, or 4K (8
MP) resolution per sensor.
l
Audio, external power, and I/O pigtail cable connector
l
RJ45 CAT5E plugs (x2)
l
RJ45 connector waterproof gland
Ensure the Surface mount adapter package contains the following:
l
Surface mount adapter (H5AMH-AD-DOME1)
l
Installation instructions sheet
l
Mounting template sticker
Ensure the dome cover package contains the following:
l
Clear or smoked dome bubble and cover (H5AMH-DO-COVR1 or H5AMH-DO-COVR1-SMOKE)
If you are installing the camera with the optional IR illuminator, ensure the package includes the following:
l
Optional IR illuminator ring (H4AMH-AD-IRIL1)
Surface Mount Installation Steps
Complete the following sections to install the device.
Installing the Surface Mount Adapter
Follow this procedure to route camera cables and install the surface mount adapter (H5AMH-AD-DOME1) to
the mounting surface.
1. Determine where the cables will enter the camera. The surface mount adapter has two cable entry
holes: one on the side and one on the bottom of the mounting adapter.
l
Use the supplied closure plug to fill the unused cable entry hole.
l
When installing outdoors, wrap the threads of the closure plug with plumber's tape to create a
watertight seal.
Surface Mount Installation 35
To Next Page
Loading...
