Note: Only use vandal-resistant conduits to route cables into the mounting adapter. Vandal-
resistant conduits will protect the cables and compliment the camera's vandal-resistant
design.
Note: When installing the H5A Multisensor surface mount camera outdoors, ensure the
conduit and its fitting are designed for outdoor use and have a suitable IP rating. Always
apply silicone sealant to seal the cable entry hole and prevent excessive moisture from
entering the camera.
2. If you are using the rear cable entry hole:
a. Use the supplied mounting template to determine the cable entry location. Drill a hole in the
mounting surface and route the conduit and cables through the hole. Install the conduit and its
fitting as instructed by the manufacturer.
b. Drill 4 mounting holes as marked on the mounting template.
c. Pull the cables through the rear cable entry hole on the surface mount adapter.
d. Use a screwdriver to secure the mounting adapter to the mounting surface with the 4 mounting
Installing the Surface Mount Adapter 36
To Next Page
Loading...
