By Length (Paper/Object)+Position: When a multi-feed is
detected for the first time, the scanner memorizes the length of
the document, the length and position of the object (photo or
label) attached to the document. When you perform next
scanning, this pattern of multi-feed will be bypassed.
To use the intelligent mode,
1. Choose your desired multi-feed detecting method to
bypass by.
2. When multi-feed occurs during scanning, a multi-feed
warning message appears.
3. Choose OK to skip the multi-feed condition from next
scanning and close the message.
4. Open your TWAIN data source in your scanning application.
The same multi-feed condition will not be recognized as
multi-feed.
Note:
1. You can clear the previous multi-feed conditions by
clicking the Reset button.
2. The scanner can memorize to bypass up to 25 multi-feed
conditions.
3. If you uninstall your scanner driver, the previous multi-
feed conditions which have been set to memorize and skip
will still be valid.
4-40
To Next Page