http://www.avl.com
Data Transfer between Test Bed and PUMA Open System
6
1.4 Data Transfer between Test Bed and PUMA
Open System
At the PUMA Open system, demand values are calculated and trans-
ferred to the output modules. At the F-FEM-DAC, the digital demand
values are converted into analog quantities (current/voltage) again,
e.g. to control a throttle actuator.
1.5 Typographic Conventions
This document uses a number of icons, text styles and typefaces to
distinguish between the various types of information found within the
text.
Fig. 3 Data transfer between test bed and PUMA Open system
1 PUMA Open PC
2 IEEE 1394 PC board PCI, via which all signals of the F-FEM
modules are transferred to/from the PUMA Open system.
3 F-FEM-DAC – digital-to-analog conversion and output of the
demand values
4 Engine test bed – analog signals (speed, torque, etc.) are
output using actuators fixed at/in the engine.
1
2
3
4
Note: This symbol introduces a tip concerning the current topic (e.g.
faster ways of accomplishing certain procedures) or a reference to
further information, other manuals, Internet addresses, etc.
Important: This box includes very important information without
which you would be at a severe disadvantage.
WARNING: Text introduced by this symbol warns of actions or situa-
tions that could potentially lead to personal injury, hardware damage
or significant data loss.
To Next Page
Loading...
