Operation instructions | MK 8-00 | MK 16-00 | MK 8-06 | MK 16-06
36 2018-10-05 | Technical improvements, changes in design, printing- and other errors expected.
3.7.10. Access to SMARTPortal
If you are a registered user of the SMARTPortal, then you can remotely control the headend via the
SMARTPortal and, if necessary, receive support from AXING.
Prerequisite is an internet connection for the headend.
In the State field, select Enabled.
Activate, if required, the option AXING support allowed.
In the field Location, enter a name for the location of the headend. This name will appear later in the
SMARTPortal to help you identify the headend.
In the field Email address, enter the e-mail address with which you are registered at SMARTPortal.
In the field User key, enter the user key that you received when registering at SMARTPortal.
Click on SAVE & REBOOT. The data is saved, the headend is rebooted and the connection to the
SMARTPortal is established.
Where required, you have to adjust the connection data (see 3.7.3 on page 32).
3.7.11. Log files
In the section LOGS you can view the Log files .
Choose Status Log.
The status log is written to RAM and starts again after a restart. In the status log for example, the lock in
time and the frequencies of the tuners are stored.
Select System log.
The system log is written to the flash memory, so it is still available after a restart. In the system log for
example, the boot time and hardware defects are stored.
To Next Page
Loading...
Need help?
General
