Axis ATA1200 - Page 60

60 USER MANUAL
__________________________________________________________________________________________________________________
To print a density determination report after all necessary measurements, connect a printer to the
balance and press key. A sample for solid mass density determination is shown below:
------------------DENSITY---------------------
Mass in the air
= ...
Mass in the liquid
= ... g
Mass density
= ... g/cm
3
Density with comp.
Water density
Water temperature
= ... g/cm
3
= ... g/cm
3
= ...
o
C
Operation sequence (weighing in air and in liquid) for below-balance weighing:
Phase I: measurement in air.
Phase II: measurement in liquid.