What to do if my Axis Measuring Instruments display shows 'H'?
If the Axis Measuring Instruments scale displays 'H', it could be due to overloading. Remove some of the load from the pan. Alternatively, it could indicate mechanical damage, in which case you should contact an authorized service.
What to do if my Axis Measuring Instruments scale displays 'unLOAd /SErvic€'?
If the Axis Measuring Instruments scale displays 'unLOAd /SErvic€', it could mean the scale was switched on with a load on the pan. Remove the load. It can also indicate mechanical damage to the load cell, requiring you to contact an authorized service.
What to do if my Axis ME-01 display shows 'L'?
If the Axis Measuring Instruments scale displays 'L', it might be because the pan is missing. Put the pan back on. If the pan is on, it could indicate mechanical damage, and you should contact an authorized service.
Why does the indicator not appear on my Axis Measuring Instruments?
If the Axis Measuring Instruments indicator does not appear, it may be due to unstable ground, vibrations, or air flows. Place the Axis Measuring Instruments scale on a stable surface not affected by mechanical vibrations and airflows. If this doesn't resolve the issue, the scale may be damaged, and you should contact an authorized service.
How to clean Axis Measuring Instruments scale?
To clean the Axis Measuring Instruments scale, wipe it with a cloth soaked in soapy water, and then dry it.
What to do if taring could not be finished on Axis Measuring Instruments?
If your Axis Measuring Instruments scale is not taring, zero the scale or press the B\G key again.
How to remove dirt from Axis ME-01 scale?
If dirt gets between the platform and the base of your Axis Measuring Instruments scale, remove the pan (lift it up), remove the dirt, and then replace the pan.
What to do if Axis Measuring Instruments shows 'SErvic(e)'?
If the Axis Measuring Instruments scale shows “SErvic(e)” when switched on with an empty pan, it indicates that the load cell has been mechanically damaged. Contact an authorized service.
What to do if the load is too big to be zeroed on Axis ME-01 Measuring Instruments?
If the load on your Axis Measuring Instruments scale is too big to be zeroed, tare the scale.
What to do if Axis ME-01 scale has improper operation?
If your Axis Measuring Instruments scale experiences improper operation due to short-lasting power supply decay, unplug the scale from the mains and then plug it in again after a few seconds.
General| Brand | Axis |
|---|---|
| Model | ME-01 |
| Category | Measuring Instruments |
| Language | English |
To Next Page
