24 USER MANUAL ME-01
12. Balance checking and adjustment
It is advised to check scale indication accuracy before and after series of measurement using any load with
known weight.
To check the scale with legal verification use a calibration weight with valid calibration certificate. In case
permissible error is exceeded it is advised to contact the nearest service to calibrate the scale.
Adjusting (calibration) scale should be made if the scale precision is not sufficient. A
standard of mass should be used with Max value taken from scale technical data table. In
case of legalized scales with inaccessible calibration (secure seal) contact with service is
recommended.
To Next Page
Loading...
Need help?
General
