USER MANUAL ME-01 67
18.15 Paperweight calculation (PAP)
This function enables to calculate paperweight
of 1m
2
of paper basing on samples of known
area. For quick access, the function is
accessible directly by pressing MENU key.
The balance must be tared just before the
measurement.
Place the specific sample quantity of the same
area (possible values: 1, 2, 5, 10, 20, 50, 100).
Press MENU key to access Function Menu. To
enter the function press
T
key when PAPEr
is displayed.
Following options show on the display:
- PAP oFF – turn off the function,
- PAP on – turn on,
- PAP n – inscribing number of paper pieces on
pan,
- PAP ArE – inscribing surface of single piece (in
m
2)
Press
T
key when PAP n and PAP ArE is
displayed.
Enter number of samples using:
0
-increasing digit,
T
- next digit,
MENU – end of inscribing.
Press
T
key when PAP ArE is displayed.
Enter area of a single sample (as above).
The result of paperweight measurement is
finished with „o” mark pointing g/m
2
unit.
In order to finish work with function press MENU
and then using
T
key choose PAPEr and
PAP oFF
Note:
“PAP Err” communicate marks that wrong values
were inscribed in PAP n or PAP ArE.
To Next Page
Loading...
Need help?
General
